I recently purchased two 5-ch light organs with corresponding control panels. Today I tested the first one which I managed to assemble in approximately 5 hours. Four of the outputs worked as intended, with the fifth permanently lit. Using the fault-finding guide and referring to the schematic I found a poorly soldered resistor from the 12V supply to pin 1 of the opto-isolator. I am pleased to report that I am now a proud owner of one self built Xkitz light organ. I am not a novice, but advanced years and shrinking of components do necessitate the use of a magnifying glass nowadays. During assembly of the main board I used dil sockets for the ic's instead of directly soldering them in, as a precaution should I have had a major problem.
I have one minor criticism; the pads to the multiplug J1 on the control panel would have been better had they been extended an extra half a millimetre at each side, the size of which currently do pose a soldering challenge. In conclusion, the Xkitz light organ is a nice project and it works very well.